Bossp

Check the file of  cdmapi32.dll  in the correct location in the folder  

Hi friend,Actualy i am using the CLK-V21 it's got failure so i need to change the new one,so i need to upload the data link table in that, Regards Baskar.P

Hi Friends, I am new to plc programing,pls explain me how i can upload the data link & online how can i see the CIO area(Which bits are enable). Thanks&Regards Boossp

Yes friend it was used,in this case which bit can recomanded

Ok friends i will it,

Hi friends, hi need cable configuration for ProPB3 C-Package HMI to system(GPW-CB02 Cable configuration or eqivelent simple cable).

hi friends,It not Reset By M8002 Also.

I am using the softwear GX Developer Verson 8.85P.It's there 500 t0 1023 latching bits but i have used M504 it's not getting hold after switch off and on. Thanks Bossp

Ok i will try my friend,

Thanks for your reply my friend,can you please explain me how we can change the plc parameter. Thanks Bossp

can you try this below configuration equivalent for SC-09 cable, PLC DIN-Mini/ PC db-9 1____3 2____5 3____5 4____2 6____1,4,6 7____5 -short connect PC pins 7 and 8 -connect connectors "grounds?" together Thanks Boss

Thanks for your support to make this cable sir, Thanks Bossp

Hi All, I new to programing in Mitsubishi fx2n plc,i want to know which memory (M) bit can hold after switch off and on the plc. Thanks, Bossp

Hi all, I wonder if anyone could help, I have old proface (prob-bin software) for this communication i used GPW-CB02 Cable unfortunately it's not communicating with my system, Anyone can help me to make the new cable. Thanks Bossp