udhaya

Hello Everyone, I want to show some data memory values in big display 43" inch LED Monitor, I'm going to use Omron CP1E PLC so please suggest me which software will be compatible, Cheap and best   Thanks in advance  Udhay   

Hi Asilva, you cant make CP1E NA20 as a slave in the Modbus RTU 485 network, its only can able to act as a Master in the network, because in a network u can use only one master, This CP1E is default master and u cant change it to slave

Hi Friends, I need an information regarding symbolic addressing in Omron, In Allen-bradley we can configure symbolic addressing in Control and compact series PLC's, Here in Omron guide me how to configure symbolic addressing in OMRON.   Thanks in advance Udhay

Anybody tell me what is he difference between Above two products, what does the term EC makes difference Thanks Advance Udhay

Hi guys, I had purchased Mobile panel 277F IWLAN, I'm trying to configure WLAN v2 config, but  I'm not able to logon to the WLAN V2 Config, i tried with factory reset password as "admin"    help me      

Hi guys, I had purchased Mobile panel 277F IWLAN, I'm trying to configure WLAN v2, but  I'm not able to logon to the WLAN V2 Config, i tried with factory reset password as "admin"    help me      

How can i establish profisafe connection with this panel and failsafe PLC, kindly help me out

Hi, I'm using Mobile panel MP277F IWLAN V2, its a failsafe mobile panel, and i'm having S7-300 cpu317pndp, i want to communicate my failsafe mobile panel with this plc, i dont have any failsafe plc after downloading the program to the HMI, while starting RT, I'm getting error message "profisafe connection is being established, want to switch off hmi?" there is only yes option is there, mobile panel connection is not getting established for normal connection, how do i disable the profisafe connection in MP277F IWLAN panel, kindly help me Thanks in advance

Hi friends, I'm using Mobile panel MP277F IWLAN, I don't know when we got it, but it was idle for few years, now I'm planning to use it for my new machine with AB controllogix, but unfortunately I can able to download the project to device but its not entering into Run time, its showing POP UP error message: " No profisafe connection Reason profisafe connection is being established do you want to switch off the device"  only Yes option is there I'm not able enter Run time without profisafe connection, How can i disable the profisafe connection in device, I had tried OS update with fresh image, but it doesn't worked Help me Thanks In advance 

Hi All, I'm facing communication problem in Proface GC 4401w with Fx2n plc (Via Option board FX2N-232-BD) I had attached the pin details that i had used, baud rate and connection parameters of PLC option board i had changed by moving values to data memory D8120, but still no result please help Thanks in advance        

Dear Friends, I'm not able to communicate with the Compact guard logix, since it has revision of 1.4, so trying to upgrade the firmware to 20.01 via control flash but it is not listing in controlflash, so i had downloaded the firmware from Rockwell support web site then also it's not listing and I'm not able to update through control flash, only through RS logix 5000 support i can upgrade the L45S firmware? if yes means from where can i get it please help Thanks in advance Note: Hardware's: 1768-L45S/B Software: RS Logix 5000 standard edition V20.01.00 (CPR 9 SR 5) I had attached two screen shots

Hi all, I'm using M340 logic controller and in that i'm adding bmxami0810 analog module, i can able to set the analog input range settings and scalings, but i don't know how to read and transfer the analog values from module to CPU memory address. Note:programming through unity pro XL V7.0, Help me Thanks in advance