kklanika2002

Is anyone interested in being contracted out to finish a PLC project. A little modbus mapping is needed to be finished up and minor changes to the logic are needed Protocol Macro is the the type of modbus were using as well.  and some display function may be needed to be changed for the NS series. 

Anyone interested in being contracted out to complete a Omron CP1H PLC project..

Okay if I Have a drive with Freqencey signal back and a 4 to 20ma signal to drive the HZ up on the drive and at 300 psi and i need to maintain a Frequency in correlation of the pump curve what is the best way to do that?

My Device Net on a SLC 500 looses certain parameters and I have to re download after each time the power shuts off. any suggestions on the fix???

Never Mind I found that the shild on the feedback cable was taped off............ I removed the tape and This fixed this issue

Okay, I have a PLC 5000 connected to a kinetics 6000 Servo drive then to a Allen Bradley MP-Series MPL 480v Rotary Servo motor Part number is MPL-B4540F-MJ72AA Servo. This servo is making a very loud noise while in the ready to run state. It is almost like it needs to be tuned. I have tuned it twice and the results are still the same. Has anyone had this issue before.....?

okay thanks yes i do have the chassis but not the cpus these were used as remote I/O.......We still use the cpu for another application.

1771-cp1 1771-A2B B 1771-ACN15/B 1771-1FE/C 1771-ALX A 1771-SDN/B 1771-ow16/B 1771-OBD/C 10-60VDC 1771-P7 D 120/220v 1771-1BD B 10-30vdc 1771-ASB/E Who buys these obsolete Items ?

Allways program useing STL it will give you the big picture of S7...........Cheers