abelito69

Hi guys, It was an issue related with the routing table , did some further research and study, had to link the HMI with the correct network with CX-Integrator the etn-21 module is as PdL described , then started to work perfect. Thanks Abel

Hi Guys , I have a setup of PLC CJ1M with a self module ETN-21 connected via ethernet with an HMI NS12-TS01B-v2 . Connection is supposed so to be ok. When the display and plc are switched on they seems to communicate but the browsing from one screen sheet to another one is really slow. Thus no alarms are being popped out like the "host has stopped or something" it is very strange because this system setup i`ve had it for another two times although i found much of the work done.I would like to see what shall i check or anything because my mind is blank atm tried many other things and i came to a point that maybe i`ve got everything wrong.there are also no errors on modules.IF anybody could help. Thanks. attached is an image of the cx-integrator , i have no idea what to do but the screen is supposed to be linked aswell i think. Tried again to download back the original programs of both plc and display ,(i amm connecting via cross ethernet with the hmi ). And i am having this error on the hmi.(see image) Abel

Hi guys , FYI , the problem wasn`t from any software or memory related , the display came with the backlight damaged! when the led near RUN starts to blink green means that there is a backlight issue! Thanks Abel

Hi guys , Here again I am requesting some help on a same screen as listed.This time I have bought a brand new screen which has no memory card and I`m trying to switch it on for the first time.Connected supply 24V and the LED next to RUN switches on green then it starts blinking green with the buzzer sounding aswell .I`m thinking maybe i need to set some of the dip switches to some positions , tried reading and everything but no success perhaps the screen must have a memory card for first use i don`t know because the last time while working on other screens had no memory card and could still upload and download to them .Tried also to connect via usb with the display but nothing happened, the PC didn`t recognize it.If anyone could point me to any suggestion or help me in what i need to do will be greatly appreciated. Thanks and regards Abel