Hi, I am new to this forum, I have a job comming up where I need to program this Zen Controller with the Zen Software "I have this also" Where I need three of the points to turn on and off in Sequence. What I need is the 1st contact to close for 1 second, then turn off, followed immediatly by turning on the 2nd contact, then do the same for the 3rd contact. So here is how it needs to go 1. when the 1st input on the controller goes from open to closed, start loop. 2. pulse output 1 for 1 second 3. pulse output 2 for 1 second 4. pulse output 3 for 1 second 5. start sequence all over again. 6. continue in this loop until input goes from a from closed position to open. If anyone here has an example of this or can draw up a quick ladder logic that would be soo much help!!! Thanks and any help would sure be appreciated......
