simppa80

What I do wrong. Have tryed with designer help topic. Cant get it work. Exel wont save it with commas :( Import says "error in address line 3 ( with txt file) or when try to import csv it made blank table..

Thank you for answer. Answer is just like I think it also. I haft to use DM area for timer setpoint. I have made 0.1 scale and BCD 1word in HMI so I dont need to set up plc timers to binary..

NS-15 and CS1G PLC. Why I cant write new value to PLC Timer? Have tried with Numeral input field. Do I need to use DM area?

Is it possible to download NS15 via ethernet and using vpn remote connection? I can connect to the PLC (at same etn network) only by FINS/TCP protocol. Not standard ethernet.

Thank you for answer. Here is I/O table:

Hi! This is my first post in here. I have started to work with Omron PLC and NS panels. I have problems getting download in CX-desgner via ethernet PC -> PLC -> NS12. I have changed primary ETN card in laptop and have tryed every setting (I think). CX-designer gives right away error : downloading / uploading failed (0006) Here is some information: IP´s PC = 192.168.2.63 PLC = 192.168.2.61 Router = 192.168.2.1 Ethernet network no. 2 NT link network no. 1 Panel communicates normally with PLC but I cant get download access via ethernet. Have read Sample program here in forum and also tryed with Omron manual. Just cant get it work. Please help. I post printscreens later here from my settings in Cx-programmer and Cx designer. CX designer.doc