hculyer
MrPLC Member-
Content count
10 -
Joined
-
Last visited
Posts posted by hculyer
-
-
As I recall, you need to connect 24VDC to the run terminal. To download the program from your PC to the PLC you need to disconnect the 24VDC from the run terminal. Be sure to double check the hardware manual first. I cannot find mine. Good Luck, hculyer -
I had this exact problem with Win 2K. I had to go into setup during bootup. I changed the serial port to com 2. Rebooted and everything worked. I hope this helps. -
Go to www.meau.com Do a search for manual JY992D97101. This should be the manual you are looking for. Hope this helps. -
Hello sirockin, You can use Medoc a dos based program to program from a pc. Here is a link for a download. http://www.plcman.co.uk/page6.html You will need an SC-09 programming cable. As an alternative you can try the programming cable Sergi posted on this forum. GX Developer will also work. -
Try this link for a download. http://www.plcman.co.uk/page6.html -
You will need the SC-09 programming cable to program. There is also an older cable but I cannot remember the part number. The DOS based MEDOC program will support the FX PLC. Look on this site for a MEDOC download. You can contact your local Mitsubishi supplier for the cable or look on ebay. The programming instructions are still avalible online www.meau.com I hope this helps -
Try these two links: For IB(NA)66490 228kb http://www.meau.com/eprise/main/sites/publ...&submit1=Search For SH(NA)3511-K 22,209kb http://www.meau.com/eprise/main/sites/publ...&submit1=Search If you still cannot connect to the site email me and I will send you what I have. -
Look at: http://www.meau.com/ goto downloads and do a search with the manual number. Both manual part numbers are good. Reguards -
Check the VFD for a torque limit. This will fault out the drive in case of a jam up. You could also use an encoder and count the pulses. You sould not need a high speed input if the conveyor speed is slow. Good Luck
FX48MR-ES CANNOT RUN
in Mitsubishi
Posted · Edited by hculyer