deadbeds

MrPLC Member
  • Content count

    11
  • Joined

  • Last visited

Community Reputation

0 Neutral

About deadbeds

  • Rank
    Sparky

Profile Information

  • Country United States
  1. error code 40

    Got a reply for AB, not what I wanted to here: You can attempt to load the firmware again. If it doesn't fix then the unit should be sent in for repair or replaced.
  2. Is there a way to fix this error code, i have a 2711-k6c2, got this error when attempting to update the firmware. Can't seem to find much in the AB website.
  3. Panel Views

    Upgrading the firmware now, the .rss file was empty, said it was a read only, no data was in it. Understood the PV file fine. Ron
  4. Panel Views

    TRIM_SHOP_NUMBERS.RSS Here are the programs I am working with, very basic, I believe they are right, it's been a while. TRIM_SHOP_NUMBERS.PBA TRIM_SHOP_NUMBERS.RSS
  5. Panel Views

    I tried the DINT and it gave me a tag/data mismatch, also, could someone send me or post an example of the N7:0 - N7:1 to one output file. I am lost on how to get both to read my series of input numbers. Thank you, Ron
  6. Panel Views

    Thank you for all your inputs, I'm going to have to move up to a 5/03 to do what I need. Everyone has been a great help in getting this old brain fired back up again. Ron
  7. Panel Views

    Ok, here is what I have and am trying to do. I am using a PV600, 2711-K6C2 3.40, and running with a SLC 501 1747-514, then going thru a 1747-AIC DH485 Link coupler to a 1761-net-aic to a PV900 2711-T9C8 3.02. I need to enter a ticket number like 98765 into the PV600 and have it display onto the PV900 at the other end of the plant. The screens are programmed and ready to run. The problem is that the highest number i can use is 65535. Is there a way to go with a larger number. My ticket numbers run up to 99999. I am not controlling any I/O, just was looking for an easy way to get the ticket numbers from point A to point B Ron
  8. Panel Views

    Ok, one more question, never a stupid question right? I have the hardware setup and working, had planned on using a counter or timer bit to carry the numbers i needed to send to the other end of the plant, problem is I am limited to the size of number 999999 cannot be used as an input because it is too large. Is there another instruction that I can use to relay a large number from one location Starting with a DATM thru a micro 1000 to another location to a PV?
  9. Panel Views

    Thank you, that makes sense now, it's been a while since I had to build anything. Ron
  10. Panel Views

    Very good point, I have a 1747 dtam and i would like to direct connect it to a PV 600 2711-k6c2 3.40 Will I need a PLC in line, or will the PV take input from the DTAM? Ron
  11. Hello, great forum. I am looking to install two panel views to talk to each other, I need to enter up to 5 lines of 6 digit numbers and have it display at a remote location, up to 1000'. I have the panel views and some plcs, 500 platform. Is it possible to have the Panel Views communicate with each other. I need to have the operator at the receiving end be able to clear the number after it is recorded. Thank you, Ron