wwkok

Dear All, Please refer to the attached trend, is that InTouch can provide multiple data in different day, but same time period? Or any third party software can do this? Thank you for your advice.

Will check it. Thank you.

Dear All, Good day to all I am going to migrate A series to Q series. Is that the encoder module A1S62LS can replace by QD75P1N? If not, please advice the correct module. I am looking as less as possible for modify the program. Thank you.

Thank you very much.

Attached with the PLC rack configuration.

Dear All, I am very new in Mitsubishi PLC. Is it possible CC-Link QJ61BT11N put in the second expansion rack? Thank you.

Dear all, I have a similar problem as well. The connection between Compactlogix L32E and Intouch Wonderware is fine for 2 weeks. But it become no connection after that 2 weeks time. CIP Msg Connection Limit is 32. Max Msg Connection Observed 31. Is that csued by the Maximim Msg connection observed very near to the limit? Thanks.

Dear All, Good day to all. Is that possible Wonderware Intouch can do web base SCADA? Thank you. Best Regards, Kok Wai Weng

Dear all, Good day to all. I am facing a problem about 1794-OE4 analog output card. When I set the raw value to 0 in PLC, by right I should get 4mA, but I get 4.8mA, it is happened for all the 4 output points, even I change a new card, the problem still same. When I try the other node which has this 1794-OE4 card, I can get 4mA. I am very appreciate if anyone can help. Thank you.

Dear All, Good day to you. There is a network connection between Allen Bradley SLC504 and Wonderware Intouch 10.1 through DH+ protocol. I have a 1784-U2DHP (USB to DH+ converter) connect from my workstation to SLC504. We know that Wonderware DAServer can support 1784-PKTX. But is that wonderware DAServer can support 1784-U2DHP as well? Than you.