BLI

I don't get it.

Thanks,PdL.It's a good idea. I'll try.

And as soon as I ask them they will tell me what the price is I can't afford to buy it.I am just a University student. And also I need it just for a month or two.Until my projects are done.

Yes,you are right but the thing is that I cannot find anywhere CX-Programmer.

Well, the PLC in the lab is Omron Sysmac, on my PC I have the Omron's software but in demo mode, which is enough for only programming.The logic that I build is being loaded to Trilogi (which I personally think is not very good) because it has some simulation mode.

Do you,guys know a kind of simulator that can be used in order to check if my logic is working? I am asking because every time when I change something in my logic I have to run to my university's lab to get to the PLC to see if it is working.I need some acceptable simulator where I could load the logic and check it in advance.That would save me much time.

Thanks to everybody for the help. I think I've come up to a solution.You guys are great

Thanks,PdL. As soon as I get to the lab I will give it a try. By the way with DIFU is very elegant decision :)

I sent you a PM

I was going to say "Why french?" when I noticed that my settings were showing that I am from Belgium. I have no idea why it was showing it but I corrected it. I've found one manual in English.I'll check it out.

Is there a special button/function for rising edge/press button because I didn't find anything? My question might seem obvious but I am a bit newbie

Thanks for the reply,pfort. How can I do it without KEEP? I used 1.01 just as an example for an output.Nothing specific.

I am trying to do the following logic - two inputs (Power and Reset) and one output (DC motor). keep.bmp I need when 01 is ON and 02 is OFF to power 101 (the motor).After that I need when press and release 02 (Reset) once to shut down 101 (the motor) even though with the power still ON. I tried something (I attached the picture) but what happens is actually keep the motor running when power is OFF until pressing once reset (02). Pressing Reset while power is ON shuts down the motor but as soon as it is released (becomes OFF) it starts working again. Any ideas how to solve this problem would be greatly appreciated. BL

Thanks

Does anyone know where I could possibly find CX Programmer?