Derik

MrPLC Member
  • Content count

    7
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Derik

  • Rank
    Newbie

Profile Information

  • Country South Africa
  1. yaskawa

    I'm using the Yaskawa JEPMC-IO2310. I'm having trouble in setting up the module in the trajexia tools program. Under the intellegent drive window I can see it but it wont allow me to use config. When I switch on power, it shows R and Active on the display. In my program I type in the output and input instructions but there's no response.
  2. Yaskawa I/O

    I'm not sure if it was an accedent but the link you gave,is a reply to your post. If I click the link, I come to a reply box.
  3. Yaskawa I/O

    I am using a Yaskawa-I/O2310 mudule for the input and outpt for the Trajexia. Since I'm using this in my final year project I don't have that much experience with motion controllers. Where can I find information about using this module, for example how to read inputs or switch outputs.
  4. Servopack

    Thanks
  5. Servopack

    I'm using the SGDH-02AE-OY servopack from Omron. Everything was working fine on my test panel but as I built everything into a enclosure things started going wrong. I was no longer able to se select the BASE to 0 on SW1 and everytime I now run my program, only one of the servopacks give me an error, A.C9. Where can I find the error codes on this servopack? Why would it just suddenly give me this error?
  6. Reference point

  7. Reference point

    Hi, I’m a university student and I’m doing a project on the Trajexia controller. I’m building a robotic arm with three axis controlled by servo’s to move chess pieces on a chess board. I want the controller to move to a reference point at start-up so that I can use a MOVEABS function to move the pieces to different positions. This is still a learning process for me so I was wondering if someone could give me some guidance or advice on this.