rosli

ok. you are rigt i tested the drive whit a HC-MF73 beacause i not have a HC-MF43 and the drive answer whit AL1A (servo combination error) and when connect a HC-MFS43 or a HC-KFS43 it answer whit Al6 (communication error between servo and driver). mny tks. for help. Josep

Hi. anyone know the schematic of MR-HCN2 conversion connector. i have a Mitsubishi MR-H60AN drive and HC-MFS43K motor. i see in the users manual i need this conversion connector. tks Josep

hi. i have a mitsu M-RH40AN servo drive and a mitsu HC-MF43 motor. reading in the manuals i dont see how to make the encoder cable for this motor beacause the motor have two pairs of signal MR,MRR and MD,MDR And the connector of the servodrive only have input for MR,MRR. The cuestion is MD,MDR are not used? if i conect only MR,MRR the driver go in A16 alarm (encoder disconected,miswired or cable short) any sugestion? Tks. Josep in Barcelona spain

hello does anybody know where i can get a program for comunicate and set up a mitsubishi mrh40 servo controller. i search in the net but nothing appears. tks Josep.

hello.. i purchased in Ebay a mitsubishi Melservo mr-h700. the cuestion is ?how i can get the comunication program for tuning it. i search in internet pages of mitsubishi and others but nothing apperars. tks. in advance. Josep from Catalonia

ok. many tks. you have solved me a great problem.

hello. does anyone know where i can get the old DOS UMON softwre. i seached in omron pages whit no luck. i need this soft. for configure parameters in a old version of servo controller OMRON R88D-UA20H. tks. Joseph