WLCHIN

Did this download available in Asia ?

Can any body tell me where to get the fuji servo controller RYS101S3-RPS-Z67 and RYS401S3-RPS-Z67 user manual

wrong address, try this one http://www.infoplc.org/Descargas/Descargas...argas-Omron.htm

Hey man!!! Password or key activated is not allow or share at this site <>

yep, i just face up this problem, i have hundre over machine using this type of plc. anyone can help!!! Thanks

Hi Yair, Few month ago, i using NTST 4.6 to upload program to NT30, after upload i found that some part is missing, nomather how i upload, still short something, nochoice i using NTWIN ver 1.0 to upload, it is succes. So may be u can try using this very old version software, but u have to prepare this software only allow Com 1 & Com 2, unless u modify this software to Com3 & Com4 or Com 5 & Com 6.

try again, that website is work!!

Try this link to get your demo software http://www.autocontcontrol.cz/rs/software_dwn.asp

Just imigine, if u are the software developer and somebody using your software without paying u, what do u thing, u already put in so many effort to deverlop a software and get nothing unless u develop it just for fun.

yes!!

I don't thing so because i buy the usb cable from normal computer shop, and the configuration same as Blast, it work find for the both syswin and cx, is that posible u didn't install the driver or some configuration u didn't fine tuning? :-p

Try this link Sorry for the wrong web site, the correct web site is

another choise, u also can download some demo software from here http://www.autocontcontrol.cz/controls/demo.asp

Hi I'm new in Mitsubishi, any body know what is the configuration of the cable SC-08 and SC-09 from computer (9 pin) to CPU(RS422)? Regard

Thank for all the guy that helping of this, nomatter how, i will try to DIY first, if not my boss everyday will bra......bra.....bra

Hi, Download your CX-Programer V3.0 here http://www.omron.sk/software/ it better than nothing right!!!!

Any body can tell me where to download the Omron PLC Reporter. Thanks

Before i post the first message, i already download and try, the url link you give is only for upgrade version, that means i should have ver 3.5 or 3.6 first, now the problem is where to download this 2 version. (Without this 2 version, whatever u download from the url you given and install it, the program always search for previous version) Any how, thank u for your reply. I hope somebody can point me to the correct url to download it.

I would like to know how to unprotect the password created by the plc CQM1, C200Hs,C200Hx. (normally is Fun49) Thanks.