Jay Anthony
MrPLC Admin-
Content count
3651 -
Joined
-
Last visited
Posts posted by Jay Anthony
-
-
Yes. If the@ symbol is in front of a function (@SUB(31)), then it will only execute for one scan.
1 person likes this -
-
-
-
Did you put the screen in Transmit mode?
-
-
Since CNTR is a reversible counter it is also a ring counter and 0 is a valid count point. Have you considered INC and DEC as a substitute?
-
I think you are right about the serial port, Bob. Serial A needs to be set for Bar Code Reader.
-
Show output instructions horizontally cannot be changed while online. Change offline.
1 person likes this -
Post your text of function block and we'll have a look at it.
-
The double bar to the lefty indicates a differentiated or one shot contact. If you look you will find in the program a DIFU instruction with the same address.
-
Do not format the card in anyway. It uses a FAT12 format and comes when you buy the card. I suggest no larger than 256mb.
-
-
Set DIP Switch 5 to ON, Auto-detect CX-Programmer parameters at the RS-232C port.
-
Good call I/O Rack! BTW, I hide stuff all the time by putting them off the screen.
1 person likes this -
-
No, expansion units cannot be used for pulse output. Only CPU OUT 100.00,100.01,100.02 and 100.03.
1 person likes this -
-
-
You will need to run MiniLSS in DOS.
-
Thanks! haven't seen you on the forum lately. I appreciate the contribution.
-
-
-
Have a Look at this discussion...
http://forums.mrplc.com/index.php?/topic/35777-omron-force-bit-cancel-via-fins/#comment-171235
It can be done but you would have to write a program to look at all bits in an area and examine for forced status.
Suggest you dig through this document especially section 4.1
Library for tcp/ip communication with CJ1W-ETN21
in Other Omron Software
Posted
https://forums.mrplc.com/index.php?/files/file/950-fins-activex-ethernet-control/