Jay Anthony

Let me get some sleep and I will do it for you.

C200H PLC does not support FINS Serial.  Use Host Link Driver.

This is absolutely the instruction sheet for CJ1W-CTS21.  Please read my comments from above. 1634330-1A CJ1W-CTS21 HSC (SSI) Unit Instruction Sheet .pdf

Start with these programs.  Change Operand 2 of TXD to #1000   TXD-RXD Quickstart Programs TXD_RXD_corrected (2)

I sent you the manual above.  Here is the Chapter 3 out of the manual.  To activate the system menu, touch any two corners of the screen at the same time.   NT20S System Maintenance Menu.pdf

Start with  these and then ask questions. CQM1H-MAB42 Instruction Sheet.pdf V020-E1-4 NT20S Touchscreen.pdf

Ehat DIP switches?  I don't see any on the module. Here is the instruction sheet.   1634330-1A CJ1W-CTS21 HSC (SSI) Unit Instruction Sheet .pdf

I think he is asking how to setup the new CX Supervisor PLC setup.   CX Supervisor PLC Setup.pdf

Use Shape library.  Also allows saving of your own custom bitmaps.   04 - Objects - Shapes and Bitmaps.pdf

TXD Transmit Operand 1 = Source word in PLC to transmit.  (Your DM0 must be set to the ASCii code to transmit) Operand 2 = Control Word which sets port number (#0000=RS232) Operand 3 = Number of BYTES to transmit less start & end code.  (2 is not enough.) AR8.05      = On when port is not busy Please use the original code in the sample program for CQM1.  Your settings are stll set to default.  Download the settings from the corrected CQM1 code.

The program you used was for CQM1H.  Please use program for CQM1.  Also please download settings..   Program for CQM1 has been added to zip file. http://forums.mrplc.com/index.php?/files/file/288-txd-rxd-quickstart-programs/

NPD100.zip

Yoou must use FTP protocol to send files to the memory card.   FTPFunction.pdf

Did you put this could in another section of the program?  Could  you have placed it after the END statement?  That  would cause it not to operate..

Did a search on old files on my server and found this section on using PRO27.  Should work for PRO15.   sec3.pdf

I would  have never (well maybe not never) thought of that. 

gtsupport is absolutely correct.  Set the mode to Hostlink.

Then you need to change the settings on the CP1E PLC to 115200, 8.2.N to match your HMI. The cable above is correct.

I didn't see where you picked that up.  From all posts, it sounds like FINS UDP.

Pages from V108-E1-05 NB series Host Connection Manual.pdf

Default baud rate is 9600,E,7,2 for CP1E.

You should be able to use Modbus RTU.

From the Jay Anthony archives: Umon.zip

Easy to use Modbus RTU Master for CP1L

I think has going to also need the programming cable, too. Universal Cable for Omron 9 Pin Port