Hi everyone,
I am new to Mitsubishi PLC. I am trying to see from where Run or speed commands goes to Servo. I have MELSEC FX2M-32MT with FX2N-1PG cards for the Servo and I am using GX Developer 8.91v
Also, I would like to mention that initially I found out that BATT V light was lit so here what I didi.
>I replaced the battery within 20 second while powered ON. Before changing the battery I took upload of the program successfully.
>I have cleared PLC memory and re downloaded the program.
> Checked Memory addresses M8005 8006 both are Low.
Now, when I am trying to run my machine it is not giving output to two Servos while a conveyor operates when started from the HMI so it means program is inside PLC, right ?
Program is attached if someone wants to have a look.
labeling mc 300322.rar