vikrantragit05

MrPLC Member
 View profile  See their activity

  • Content count

    4

  • Joined

  • Last visited

Everything posted by vikrantragit05

  1. Hi all, There is a scenario where I need to connect PLC to a Server and get data on KEPServerEX.   PLC (micrologix 1400 password protected) IP-192.168.1.10 subnet-255.255.255.0 Gateway- 192.168.1.1   Server IP-10.10.91.11 Subnet- 255.255.254.0 Gateway- 10.10.91.1   Is there any way out to establish communication between these two without any modification in server/PLC by any additional h/w means (switch/router)?   Thanks in advance.
  2. Hi all, I am trying to communicate KEPServerEX with FX3GE vis UDP protocol. I have tried but unable to get data on Kepserver. While configuring communication properties in PLC we have configured PLC IP, PLC Port, Destination IP, but unable to find correct Destination Port. Although we tried various port nos like 49320, 57412, 57512, 56233, 1025, 32402, 57212, 57012, 57612, 57812 but there was bad quality data using UDP For same PLC using TCP/IP we were able to read all tags properly. This change in communication protocol is required as there are some PLCs whose communication port drops after few days of connection establishment (no error logged; can be re established with just restart). Someone from Mitsubishi said to try communication via UDP as it continuously fetch data regardless of kind of response received. If anybody has tried or have any solution, please do share.   Thanks

  3. FX3GE communication with KEPServerEX via UDP protocol

    vikrantragit05 replied to vikrantragit05's topic in Mitsubishi

    Hi Mark, Thanks for the support. The verification was successful with the tool mentioned above. Still I am unable to connect KEPServer to PLC with same config. If there's anything you have tried, please so share.  

  4. FX3GE Communication issue

    vikrantragit05 posted a topic in Mitsubishi

    Hi all, There's an issue I am facing for multiple FX3GE PLCs in a plant. Communication breaks between a PLC and OPC server. PLCs after few days (4-10) does not respond over ethernet. No ping response is received over network as well as when checked one to one direct connection. If I restart the PLC the connection is resumed and again after some days it goes down. Error LED on ethernet port does not glow red (no indication for error). If anybody has faced similar issue and has resolved, please share.