Cagey93

Thanks for the reply, yes, I can see the interrupt section, it refers to 0.03 now I looked again. Think I get the gist of it, will look at the manual as you say. cheers, Philip

Thanks for the reply, not just sure how to do that but it makes sense, will have another look.

Hi all, new to Omron plcs.  I have a baggie machine with a print registration eye into input 0.03 and a servo drive pulse on output 100.00 and direction on output 100.01.  I uploaded the program and all comments were illegible as the machine is from Malasia but I relabelled as many i/o as I could from wiring diagram but cannot find any of the input or outputs I mentioned above?  I have done a few minor program changes and written them to plc with no issues but I would like to see how these i/o function as I am having issues with registration sometimes. Anybody have any suggestions?

Thanks, will have a look. Think I looked at this but didn’t think it would fit the 3s? cheers, Philip

hi, may sound simple but I am struggling to connect my got GT1030-HBD2 to an fx3s plc. After much digging, I have found that my got screen has RS232 format connection strip and the plc is 422 format. I think I need an RS232 to RS422 converter?  The terminal strip on GOT screen has markings : SD,RD,ER,DR,SG,RS,CS,NC,NC. Drawing below shows my terminals on right hand set, left hand set is the normal set for fx plc Can anybody help? Regards, Philip

hi, may sound simple but I am struggling to connect my got GT1030-HBD2 to an fx3s plc. After much digging, I have found that my got screen has RS232 format connection strip and the plc is 422 format. I think I need an RS232 to RS422 converter?  The terminal strip on GOT screen has markings : SD,RD,ER,DR,SG,RS,CS,NC,NC. Can anybody help? Regards, Philip