Hi,
I have a CP2E PLC (CP2E-N30DRD) with an Analog In/Out board CP1W-MAB221.
I can't find a method to setup it correctly (the ERR LED is fixed in ON state).
The "W516 (Section10) CP1L-EL_EM ANALOG OPTION Boards" manual
says to "set the baud rate of the relative option port at 115200bps in Toolbus
mode.", however in CX-Programmer , under "Settings" and "Serial 1" tab there is not
such protocol.
In w614 (cp2e software manual) and w613 (cp2e hardware manual) I haven't found any other tips.
Can you help me please?
Thank you.