Stefano A.

MrPLC Member
 View profile  See their activity

  • Content count

    2

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Stefano A.

  • Rank
    Hi, I am New!

Profile Information

  • Country Italy
  1. Stefano A. liked a post in a topic: CP2E and Analog In/Out (CP1W-MAB221) setup in CX-programmer "settings"
  2. It works. Thank you!
  3. Hi,  I have a CP2E PLC (CP2E-N30DRD) with an Analog In/Out board CP1W-MAB221. I can't find a method to setup it correctly (the ERR LED is fixed in ON state). The "W516 (Section10) CP1L-EL_EM ANALOG OPTION Boards" manual says to "set the baud rate of the relative option port at 115200bps in Toolbus mode.", however in CX-Programmer , under "Settings" and "Serial 1" tab there is not such protocol. In w614 (cp2e software manual) and w613 (cp2e hardware manual) I haven't found any other tips. Can you help me please? Thank you.