Marraud arnaud

MrPLC Member
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Marraud arnaud

  • Rank
    Newbie

Profile Information

  • Country France
  1. Read Analog sensor with CP1W-MAD44 on CP1L E

    I found the error, as you said, I had to use the configuration words 102, 103, 104, 105 and with the recovery words 2, 3, 4, 5 because it is the first card after the CPU. And now it works. Thank you it was a rookie mistake, Sorry for the inconvenience.
  2. Read Analog sensor with CP1W-MAD44 on CP1L E

    The page attached (With comments) is the OMRON documentation. My program is on the second page with green lines. In the configuration words I write : in 104 : #80EE (10000000 1110 1110) 4-20mA average. in 105 : #8000 (10000000 0000 0000) Not use. in 106 : #8000 (10000000 0000 0000) Not use. in 107 : #8000 (10000000 0000 0000) Not use. And after to recover data I move 6, 7, 8 and 9 in variables. The desired configuration is to use just the 2 inputs for 2 sensors 4-20mA and don't use the other I/O. And if I do like you say, if I change configuration words  102, 103, 104 and 105 it's the same result. It may be my wiring, but it is nevertheless simple. How can I check If the MAD44 works, or if the there is a link between the MAD44 and the CP1L ?  
  3. Read Analog sensor with CP1W-MAD44 on CP1L E

    The PLC is a CP1L-EM30DR-D.  
  4. Read Analog sensor with CP1W-MAD44 on CP1L E

    No I just have this card
  5. Hi everyone, I want to read analog signals of sensors TW2000 and O5D150 (IFM), to read these signals I have a CP1L E with a CP1W-MAD44. I wired these devices like this : (With pictures attached) L- à Blue à 0V à COM L+ à Brown à 24V OUT1 à Black à I in 1 à V in 1 And I made the program attached like the doc omron say. But I don't have any signal. I don't know what I forget, I'm a beginner in the CX programming. Thanks in advance. Arnaud