berkotropia

MrPLC Member
  • Content count

    2
  • Joined

  • Last visited

Everything posted by berkotropia

  1. Unconverted Ladder Code?

    Hi BobLfoot! You were right!!! The problem was that I did not press F4 (build) before saving! Many thanks! I am very new to PLC programming and ran into problems what is obvious to advanced people! :)
  2. Unconverted Ladder Code?

    Hi All, Please see attached screenshot: Whenever I want to save the ladder program or start simulation, this window pops-up. If I press 'yes' I loose the whole work. I tried to open existing program and modify it, but it did the same. When I clicked 'yes' I lost all modification and just the original program remained. (I made the program in the morning, opened and saved many times but it started popping this window later.) I work with FXCPU series, FX3U/FX3UC type, simple project in ladder. This worked well but now is not anymore. I use Melsoft GX Simulator! Can anyone advise why this is happening? It is very annoying! It is pointless to work on anything now! Many thanks