Matax

Thank you for helping me. I will propably do it with the ethernet port then.

Yes I am using source wiring for DSS PLC, so I wired servo amplifier also source way. So does that mean i can't do anything to fix this problem other than switching PLC or servo amplifier. I thought there was an error in my program, because everything else worked, just the pulses I was sending didn't work. I wired the servo amplifier as shown on image, but I switched the + and - on the voltage source.

The Pulse Input I have on Positive logic and Pulse train + SIgn. "I am using position control mode and using CH3 on servo amplifier for high speed I/O" by this I mean that, I am not using the CN1 (ethernet connection) for PLC and servo amplifier where you don't need to set the high speed I/O. I want to control the servo amplifier with CN3 where I need to set the high speed I/O.

If the ALM is on it means there is no alarm.

Hello! I am using servo motor (HG-KN13J), servo amplifier(MR-JE-10C) and PLC(FX5UC-32MT/DSS-TS). Using programs MR Configurator2 and Melsoft GX Works3. I am trying to make the servo motor go to a position, but it just doesn't turn. I checked if maybe the pulses are not going through the PLC, but with testing i saw that the PLC is outputting pulses. I a using position control mode and using CH3 on servo amplifier for high speed I/O. I tried using PLSY, DRVI, DRVA and DRVTBL, none of these blocks make the servo turn. Im thinking maybe there is something i have set wrong in MR Configurator2 or maybe I don't have high speed I/O set right. I checked all the datasheets, looked at tutorials for beginners and still didn't find a way to turn the servo motor. Maybe u guys can help me.