Phuongdian

I have sent you an email, looking forward to your help!!!! Thank you very much !!!

OK, I got it, thank you very much for your help with some of my questions!!

Thank you for your reply!     Sometimes I have Mr-J2S-100B-EE085 damaged, but I can only buy Mr-J2S-100B so I want to copy the firmware from Mr-J2S-100B-EE085 to Mr-J2S-100B     The software you recommend is MR Configurator2, if I find out, it seems to be used for Mr-J3 and higher, and how to use it to copy the firmware, can you guide me?      Thank you so much!

Thank you so much for your support!!!     I'm busy so I reply late, sorry!!!     Through your instructions, I also tried to change the internal resistance but still can't fix it     What do you use to measure the motion profile?     Can you tell me more: how to copy firmware from one driver to another?   Thank you very much!!!!

Hello everyone!!    I have 2 drivers Mr-J2S-100B and 1 Motor HC-SFS102.     - Driver 1: I run Test Jog mode at 2000 r/min and set Accel/decel time: 100ms, when Stop, Driver error AL30 (sometimes E0 or E1), then Bus voltage up to 380V     - Driver 2 has the same parameters as Driver 1 and also tested the same but no error Please help me to fix Driver 1!!!! Thanks very much!!!!

Thank you for your reply    I have tested: - Cable encoder and Motor HC-SFS352 with MR-J2S-350B is OK - Driver MR-J2S-350B-S041U703 is OK.   However, Driver MR-J2S-350B-S041U703 is driver for Linear Servo, I have referenced: "https://forums.mrplc.com/index.php?/topic/36026-mr-j3-10b/" but still giving error AL20

Hello everyone!     I have MITSUBISHI MR-J2S-350B-S041U703 and motor HC-SFS352 when connecting error AL20, can you help me!!!