der0492

MrPLC Member
  • Content count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About der0492

  • Rank
    Hi, I am New!

Profile Information

  • Country United States
  1. Thanks, Good information, everything makes sense. Also on Tech Connect chat.I was informed that ground noise might also contribute to this issue.
  2. This is a 1756-IF8 rev 1.5 Analog Input module. This has happened a couple times where the Module Input Data, (not mapped), goes to the high limit and freezes (Data Monitor data is static).  Plant operators pointed out the trending wasn't accurate. There is no fault on the module, no yellow triangle on the system tree for the module.  The Module properties show no faults, and RUNNING. I have done a "Reset Module" both times, (Module Properties - Module Info tab), while monitoring the module data.  As soon as it resets, instantly the Data Monitor starts showing live data. I'm going to try and replace the module at first, but I have some concerns. Has anyone run into this before? I can't seem to find any information on the "Reset Module" animation, and what it actually does.  Any information, (or where to look), would be appreciated. I don't like to hot swap, but I believe I will need to in this case, (utility).  Will the current properties, e.g. scaling transfer to the new module? Thanks Dave Redman