seanp123

MrPLC Member
  • Content count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About seanp123

  • Rank
    Hi, I am New!

Profile Information

  • Country United States
  1. Any thoughts ? Thats what it sounds like to me too, but we've changed out the feedback cable and even put a free-spinning motor connected to new cables on the drive and immediately got the same error.
  2. Hi all, I'm having an issue with one of the Kinetix6000 allen bradley servo drives on a filling line that I support. This particular servo motors controls the rotary movements of a series of pumps to ensure accurate dose timing. Every time that I start up the machine, the PLC (Controllogix L7 firmware v28) executes a homing sequence to ensure the servo finds its 0 point. However, the servo in question keeps getting an 'Overspeed Fault' (E55). So far in troubleshooting, we've basically changed every component. We replaced the drive, feedback cable to the drive, and even hooked up a new free-spinning motor directly to the drive. Every component change has resulted in the same Overspeed error shortly after the homing sequence starts. To try and rule out a mechanical issue, I even disabled the homing sequence in the PLC and tried to move the motor using Motion Direct Commands. Immediately after a MSO command, the drive faults out for OverSpeed even with no motion. The last bit of troubleshooting we swapped the position of two of the drives, but the same OverSpeed fault happened on the drive connected to the rotary movement motor. At this point, I'm even considering changing the sercos fibers and the Kinetix power rack. Has anyone experienced anything like this before, or have advice on what to try to make it work? Thanks in advance for all your help