jorism

MrPLC Member
 View profile  See their activity

  • Content count

    8

  • Joined

  • Last visited

Posts posted by jorism

  1. Posted · Edited by jorism
    update

    Hi

    I have done the above for most these 3 I can't see in the communication settings:

    • DIP switch
    • start bit
    • host link mode (found this and is correct)

    where can I find these settings?  which menu?

  2. Posted

    I dont know what to debug.  If I check the device, it shows the com port and all mentions to be working correctly.  My communication settings in cx-prog, are also the same as the converter device.

    I can check to buy a keyspan adapter if no other solution found

  4. Posted

    Hi chelton

    I dont see the pinouts at my pc.the out end of the cable connected to the plc  is female and i plug in an rs232 serial to usb converter model xs8801. Is used to work with one from profilic and it worked untill suddenly with windows 10. Identical set up.  I guess my answet does not help ? 

  6. Posted

    Hi Wasan,

    I did this.  The port is found as COM9 and this is also the port I'm using for the communication through cx-programmer.  When I try to go online, I get the standard message of "failed to connect to PLC.

    The DLL error is on the other PC.  I have done a standard installation, nothing special, but it feels like it came up since a windows 10 update

     

    Any other options?

  8. Posted

    I have an omron PLC (CJ1M type) at home which I would like to connect to, however, lately, I can't anymore.  I'm trying on two different PC's a newer and an older one, both running on windows 10.

    1 is just mentioning a DLL error and I can't even start cx-programmer, the other one seems to work, however, when I try to go online it always fails

    I'm using a usb to serial device and after some searching on the net, I thought the issue was with the prolific driver.  I tried all kind of fixes, but nothing seemed to work. 

    I have now purchased another device, the XS8801 from usconverters and installed the latest driver.  I have checked if cx programmer is set to work with the correct port and this is the case.

    My knowledge is very limited but I would really want to connect to that PLC again, so hoping someone out here is able to help me.

    Thanks a lot