lqu@edgeautomation.ca
MrPLC Member-
Content count
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Calendar
Everything posted by lqu@edgeautomation.ca
-
Unable to delete a screen
lqu@edgeautomation.ca posted a topic in Allen Bradley / Rockwell Automation
Hello AB professionals, I am using FactoryTalk View Studio v11. I am basing on an old project to build my application. I restored the project from a .mer file. I deleted or renamed some old screens, saved and closed the project. But when I open the project next time the screens I deleted still show up. When I click on it it will show an error message "Component does not exist". In the FactoryTalk ME application, I right click a screen name on the left tree under the Graphics, and then click "Delete" or "Remove", the display would disappear at that time. But it persists on coming back next time I open the project. If you know the solution to resolve please reply. It is much appreciated. Thank you. Lei -
Panelview Panel + 7 900W Unable to connect
lqu@edgeautomation.ca posted a topic in Allen Bradley / Rockwell Automation
Dear Professionals, I set up a communication link to my PLC in the FactoryTalk View ME and then create a mer file. When it finishes, it shows up a pop that says an unsupported device detected. Please see the attached photos. Can you please give me a hand on this if you know the solutions of resolving it? Thank you very much. Lei -
Panelview Panel + 7 900W Unable to connect
lqu@edgeautomation.ca replied to lqu@edgeautomation.ca's topic in Allen Bradley / Rockwell Automation
@ all Thank you so much for helping me on this issue. Eventually I found it was a basic problem I have neglected. My controller is V32, and the HMI is V10. So they don't match. upgrading the HMI to V11 solves this issue. However, when I use ME Transfer Utility to download the mer to the HMI, it shows an error. Please see the attachments. Any insights to this issue? Thanks. Lei -
Panelview Panel + 7 900W Unable to connect
lqu@edgeautomation.ca replied to lqu@edgeautomation.ca's topic in Allen Bradley / Rockwell Automation
Yes, I did copy the Design to the Runtime. I tried the three spots up approach and it does the same thing. At the end of the mer creation, it shows up a error message in the txt file attached. When I download the mer to the HMI, it shows an error that is is in the photo below. Any ideas? Thanks. Lei 5103_05_MasoniteValidationResults.txt -
Unable to delete a screen
lqu@edgeautomation.ca replied to lqu@edgeautomation.ca's topic in Allen Bradley / Rockwell Automation
Thanks, Joe. -
Unable to delete a screen
lqu@edgeautomation.ca replied to lqu@edgeautomation.ca's topic in Allen Bradley / Rockwell Automation
Thanks, @pturmel.