muhammadalisoenh

MrPLC Member
  • Content count

    12
  • Joined

  • Last visited

Community Reputation

0 Neutral

About muhammadalisoenh

  • Rank
    Sparky

Profile Information

  • Country Indonesia
  1. CP1W TS001

    Hai, I have problem with my CP1W TS001, suddenly reading result always #7FFE.  i use CP1E-N60 and 2 expansion module, AD041 and TS001. I put TS001 after AD041 then my program code as follows : mov #8051 105 mov 7 D20 mov 8 D22 the reasult at D20 & D22 always #7FFE could someone help me to solve this problem?
  2. CP1W AD041

    Okay, Mr Suresh, i'll try your sugestion  Thanks a lot
  3. CP1W AD041

    here is my program reading 1-5 v analog input
  4. CP1W AD041

    i use PLC input address CIO 000, CIO 001 and CIO 002, so CP1W-AD041 address should be start from CIO 003 right?
  5. CP1W AD041

    Okay, i'll try your sugestion
  6. CP1W AD041

    Hi.. I have a problem with my analog CP1W AD041, it's reading value always "0". Can someone help me to configure software setting? I use PLC CP1E-N60SDT-D Thank you        
  7. MAD44 ANALOG I/O PROBLEM

    i use 103 - 106 as output words and it works, i use 4-20mA on analog 0 and 0-10v on analog 1. i move #809E to 103 and it works thanks very much
  8. MAD44 ANALOG I/O PROBLEM

    I had read sample ladder from manual on page 8-54, values moved to channel 104, 105, 106 & 107 for mad44?  So, based on manual page 8-55 input value adressed in channel 6 & 7 I don't know how it could be different betwen manual and your explanation?  Thanks 
  9. MAD44 ANALOG I/O PROBLEM

    i use CP1E-N60SDR-A PLC i just intalled one expansion, only CP1W MAD44. 
  10. MAD44 ANALOG I/O PROBLEM

    Hey, i was reading analog i/o from 4-20mA & 0-10V analog sensors using MAD44 connect to CP1E series PLC. my problem is the reading result always 0000 Hex. i had measure voltage on MAD44 input terminal there was 2,5 v. any help is greatly aprecited.