[NX102 SSI encoder problem]

hi
have a good time

i have a nx102-1200 and a nx-ecs212 module.

I connected an SSI encoder to the card and read the position value in the software.
The encoder counts 360 pulses in each round and then it goes to zero.
I want to use GearIn function and have the encoder as the master and a servo motor as the slave.
In each revolution, the encoder pulse becomes zero, and as a result, the servo motor movement is not continuous!!!
I want the servo motor to be continuous! In fact, I don't want the encoder pulse to zero every time.
What should I do? Is there a solution?

please help me
thank you so much

[connect encoder to nx1p2]

7 hours ago, viman said:

The variable in question is registered on the IO Map menu just like any other input/output. There you can see what data type the encoder value is using and assign a name to it.

I suggest you enable the Controlword input (I think - need to check this) on the card's side parameters, since I have needed to reset and enable manually the encoder reading in every single application that used one.

Thanks for the tips

but actually my question is how do i do the program.
do you have any sample program or example manual?

thank you so much

[connect encoder to nx1p2]

11 hours ago, Crossbow said:

You wire the encoder to the encoder module and then set a variable in the program where you can read the value of the counter.  What you do with it after that is up to your program.

thanks

[connect encoder to nx1p2]

hi everyone
i have a question about nx ec0122
i connected an encoder to ec0122. now i want creat a programm for read the pulse and reset pulse. Then write a program to measure the length of a roll.
How should I do this?
Thank you for your help