garywalsh
MrPLC Member-
Content count
12 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout garywalsh
-
Rank
Sparky
Contact Methods
- ICQ 0
-
Hello. I currently have a C200H system running on a machine that has the following I/O card setup. OUTPUT, BLANK, OUTPUT, OUTPUT, INPUT. My question is: Can i add an additional input card in the spare slot between the two output cards? thanks in advance.
-
Hello.. I have been able to upload screen and table data to NTSS v4.6, i have made a minor change and now wish to download tables back into the NT20s. The software goes through the motions but the changes to not appear to have been written when i check. If i use NTSS v2.33 it will not allow me to download as it says the screnn is in eeprom. Stuck!!!!!
-
Thanks sleepy, that was it...I never realised that, handy piece of info thanks....
-
Thanks, i will check it out and get back to you.
-
Hi... I am adding a couple of counters to monitor some inputs, when i download the program to the plc and then put in run and monitor the counters dont decrement, the PV just jumps around. I am using 253.15 to reset the counters and this seems to not work either as the PV does not set to the SV. The counters i have added are below. LD HR28.01 LD 253.15 CNT 001 #3000 LD 002.07 LD 253.15 CNT 002 #3000 Any ideas?? Gary.
-
Help... I have added a new block into a cqm1h plc program and it only has a couple of simple set reset networks in, problem is they do not seem to operating. The set function changes in monitor mode but the output it is setting does not? Any ideas. Gary.
-
Hi.. Where can i get a copy of the dos version, or NTST V3.2
-
Hi.. I have replaced a faulty NT20S with another, taking the files out of the old one and putting into new one. Some of the functions work but some dont. I have transfered all pages etc but i am not sure i have done it right. Any ideas. Thanks Gary.
-
Help.... I am trying to upload from aN NT20S. I put the NT20S into comms mode and then try to upload from support tool but get timeout error. I am using the same cable that connects the NT20S to the PLC, is this correct? Set baud rate at 9600 on my laptop but what about other comms settings, data bits etc???? Thanks. Gary.
-
Hello.. I have just installed the NT SHell V2.2 software on my laptop and i need to change a faulty NT20s touchscreen. I assume i need to download the program from the faulty unit and then upload to the new one. How do i do this? Also if i try to start a new project i get an error message saying 'failed to open editor' Help.... Gary.
-
Thanks alot........Got info i required.... Regards. G.
-
Hello. I am trying to set up a MAB42 analogue input card to read a range 0-5v. I am unsure how to do this ? Any answers appreciated. Gary.