Linlar

MrPLC Member
  • Content count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Linlar

  • Rank
    Hi, I am New!

Profile Information

  • Country Canada
  1. Good day, Looking for information on this converter, I have not worked alot with the plc side of things but do have a decent understanding. I have a Mitsubishi Temperature converter AL2-2TC-ADP on a piece of equipment connected to the input of an Allen Bradley 1100 Micrologix PLC unit. It is a type K to 0-10 vdc converter, i am getting the incorrect readout on the AB 1100 display screen. The Type K TC sensor reads correct up to the converter with my calibrated meter. The sensor is approximately 10F to warm.  In looking at the specs of the converter, it states its compensated range is -58F to 825F I am assuming this would represent the output voltage, -58F = 0vdc / 852F = 10vdc? i would like to confirm this so i a can measure the output volage and see if the converter is in fact operating properly. I do not have the software or the program to dig into the Allen Bradley Micrologix 1100 PLC, it is factory programed and i am getting very little response from the factory tec support.  Any help would be appreciated. Thank you Larry