Becky
MrPLC Member-
Content count
5 -
Joined
-
Last visited
-
I am already using one fx3g-232-bd modul, and the PLC only has room for one more on the rs-422 port (picture below). That is 2 readers max. I need 3 for the project, so i guess i will need to change to rs485 or 422 to make that possible, but I could not yet find a solution that would work
-
Hello, I need to connect multiple barcode readers (SICK CLP510) to a PLC (FX3GE-40M) for a university project. I need a minimum of 3 bar code readers, but only have one operational, connected via an additional modul for the use of rs-232. The only other port I can use is a miniDin 8, which is a build-in rs-422 port. Because this is a university project, it needs to be as cost efficient as posible. All the readers are CLP510 (pin-out attached bellow) Thanks Becky Pin_out___wire_colour___signal_comparison_CLP100_CLP510_CLV60x.pdf
-
Hello, I need to connect multiple barcode readers (SICK CLP510) to a PLC (FX3GE-40M) for a university project. I need a minimum of 3 bar code readers, but only have one operational, connected via an additional modul for the use of rs-232. The only other port I can use is a miniDin 8, which is a build-in rs-422 port. Because this is a university project, it needs to be as cost efficient as posible. All the readers are CLP510 (pin-out attached bellow) Thanks Becky Pin_out___wire_colour___signal_comparison_CLP100_CLP510_CLV60x.pdf
-
Hello, I'm trying to execute the loopback test on the RS-422 built-in port of GX3GE-40M. I connected the TxD pins to RxD pins (+ to +, - to - ). I'm trying to use the function rs2 (later the plc should communicate with a bar code reader). I have tryed all possible connections, to see if the PLC can read the signal as well as transmit it. It manages to transmit the signal, but I cannot get it to read it. Could someone help me troubleshoot if the problem is in the program portion? I'm working in GX Works2 Thanks for any and all help test_plk.gxw
-
Hello, I have a project in which a bar code sensor and PLC need to communicate. The sensor is a Sick CLP510-2000 and uses RS-232, PLC is FX3GE-40M and does not have any extra moduls, such as the FX3G-232-BD. I was hoping the comunicatiom would be possible trough the minidin8 cable, until I got to GX Works2. It looks like I need the RS or RS2 function, but in help it says it only works with the extra moduls. Does anybody know, how I could make a function, like RS or RS2, or use one of them without the modul? Thanks in advance for any help you can offer :)