PlcAmtr

MrPLC Member
  • Content count

    8
  • Joined

  • Last visited

Community Reputation

0 Neutral

About PlcAmtr

  • Rank
    Newbie

Profile Information

  • Country Denmark
  1. Q02 / Q71E71-100 Network settings

    Yes. I read from PLC ASCII code enabled. By sending an ASCII command to the PLC afterwards I get an error code in Binary C080 that is: "ASCII command used when Binary code set".
  2. Q02 / Q71E71-100 Network settings

    the PLC runs an empty program.
  3. Q02 / Q71E71-100 Network settings

    a) did that b) as long as I continue to send the commands in binary mode no error will pop. The error LED lights up when I send in ASCII, the code mode that is set. Ports 5500 and 4999 are not in the the range mentioned. The PLC worked fine before removing the battery. The question is what changed and how it can be undone/restored. I did before the Online -> Format PLC memory, and just did it again now. No change in the status (still locked in binary code, and new open TCP ports unreachable). 
  4. Hi experts :D Can anyone help/try to help  with the following conundrums: a) when changing the Ethernet Operation settings from Binary code to ASCII code, the setting are 'saved' in PLC settings, meaning that ASCII code is read as selected after a restart, but the PLC accepts commands and responds in Binary code. b) when adding a new TCP port, the new port is 'saved' in PLC settings, meaning that read as selected after a restart, but the PLC refuses commands on that port (the "Open" LED on the Q71E71-100 card turns on for the duration of the transmission but no reply is received from the PLC) notes: setting software: GX Works 2 target test software: Custom made Driver for MC protocol. (tested and working with FX and Q series  and with ASCII and Binary code) PLC model Q02 (reset performed by removing the battery for more that 2 hours) ports used for test are: 5500 and 4999 (decimal) found 5002 port opened by default (no open setting required) PLC network module Q71E71-100 (new)   I would upload screenshots of the settings but I get this error: "There was a problem processing the uploaded file. Please contact us for assistance."
  5. List of protocols

    I develop a piece of software that reads and writes data from/to a PLC using MC protocol. I test it on a FX3GE unit using 1E frame. I would like to know which other models i can use with my current software and for which ones use a different frame type since i want to expand my software further.
  6. Hi everyone, can someone help me find a list of Mistubishi PLC models based on which communication frame from MC it uses? (Fx: FX3GE : E71.1E)
  7. List of protocols

    Hi everyone, can someone help me find a list of Mistubishi PLC models based on which communication frame from MC it uses? (Fx: FX3GE : E71.1E)