Hello,

I am trying to program the analog output on L20BWB-5A (24VDC power supply) PLC from Allan Brandley. I've been searching this site for examples but I can't find anything. Does someone has a small program / example for me. That would help me a lot.

Greatings,

Jeen Wouda

Can you be a little more specific about what you are trying to do with it?

hello,
try to get ml1000 user mannual from ab.com init u hav how to configure it

Thank you for the replies but I already succeed in configuring the analog output.

So what exactly are you trying to do?

As far as sending values to the analog output put something in O:0.4. 0 is 0VDC or 4mA and 32767 is 10VDC or 20mA depending on whether you have set it for voltage or current.

Download THIS manual and read chapter 5. It should guide you through the scaling and any other issues