I purchased a Deckel FP4NC. When I got into the setup of the machine I found the unit had been upgraded with Anilam controls. The pc was a Gateway 386 which I have since replaced with a newer pc. The problem I have is that whoever took the Allen Bradley SCL500 out of the control box. The other problem is that the ladder logic program was never backed up into the pc.
So I was wondering if anyone on this forum has developed a ladder logic program to run any of the following machines. FP3NC, FP4NC, OR FP5NC.
If so I would be interested in the bit map, flow chart, or ladder program that could be used in my machine.
I do have a logic flow chart in german for a fp--nc.