Forums.MrPLC.com > PCMK under DOS

Forums.MrPLC.com > PLCs and Supporting Devices > Allen Bradley

modesto

Mar 9 2003, 07:52 PM

Hello guys.

I have to use PCMK series B under DOS using A.I. series software...I know that Icom have your own drive to comunicate with the PCMK but I dont know if DOS needs a driver too. I've read in PCMK manual about PCMKINIT.COM file...I've tried to run this file but a message appears telling that I have to install a card service too. I've called for Rockwell Suport and they tell: "You must install Cardware software!". Is this correct? In PCMK manual, I've read that Cardware is only used with 6200 software.

Any idea how can I do this?

Thanks.

GATI

Mar 13 2003, 10:34 AM

You must install CardWare Software to enable PCMCIA Sockets in MS-DOS, without CardWare you can´t communicate with 1784-PCMK.

GOOD LUCK

Guest_modesto

May 10 2003, 06:14 PM

Any idea where can I get download Cardware from internet...or its not possible?

Thanks again.

This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.