dear all,
i have a problem to upload the motion program stored in IC693apu302 module
i need the software "APM" and the pin assignment of the cable between PC and APU302
thanks
Full Version: GE Fanuc problem
http://gefanuc.bnsi.net/eforum/showthread.php?t=13991
You use the same csblr for the APM module as you would to communicate with the PLC through the 15-pin port on the power supply.
You use the same csblr for the APM module as you would to communicate with the PLC through the 15-pin port on the power supply.
QUOTE (Steve Bailey @ Nov 3 2009, 07:03 PM) 
http://gefanuc.bnsi.net/eforum/showthread.php?t=13991
You use the same csblr for the APM module as you would to communicate with the PLC through the 15-pin port on the power supply.
You use the same csblr for the APM module as you would to communicate with the PLC through the 15-pin port on the power supply.
thank you very much
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.