Hi i an using a high speed counter actvated by the high speed inputs.

the data is being read in 230

230 runs from 0-100 each cycle of the machine and works well. i have 7 cams running from this AR11.00 to AR11.07

i have also used CMP(20) to compare data from a HMI (DM0150 input and 230 and when equals sets a output on and then CMP again to reset the output.

is there any reason any one knows why this not a good way to turn address on - off through machine cycles.

machine cycle spped from 1-120 a min

anyones comments would be apprecated

regards


leon