Hi everyone,

I new to this site, this is my 1st posting here. Well I am having problem to read from Omron RFID (V600-CA5D02) linking to my port no.1 of SCU-21 unit. I have gone through the manual, all i understand i must use the protocal macro to link with the RFID unit, but i cannot can get any response from the unit.
I also not familiar with the protocol macro how to read this reading from the RIFD. I try Using Test on the RDIF, it seem is working as it should. i think my problem is in the programming & protocol macro.

When i turn ON the PMCR instruction in the PLC, the bottom is what i see in the SCU21-V1 indication

SCU21-V1
RUN-Always On
RDY-Always On
SD1-Blinking
RD1-OFF

On V600-CA5D02
RUN-Always On
COM- OFF

COM1-OFF
Norm-OFF

My hardware
CJ1M-CPU12
SCU21-V1(slot 0)

RFID
V600-CA5D02
V600-H07

The hardware dip switch for On V600-CA5D02 is set according to the parameter in PLC IO Setting

I suppose my program will write in DM2020 & read from DM2050 when my PMCR active

I cant seem getting any read out from DM2050 when an ID tag touch my V600-h07 which is link to my V600-CA5D02

Can anyone teach me how i suppose to configure my header+data+end code in my protocol macro?

Please help!

Thank you!

Regards,

sttchui