Forums.MrPLC.com > Set all CP1L settings to factory settings

Full Version: Set all CP1L settings to factory settings

Forums.MrPLC.com > PLCs and Supporting Devices > Omron

electron

Aug 17 2009, 10:47 PM

Hello All,

Due to CTBL range comparison always error, i make change to CP1L setting, as in attached picture,
fortunately now i can't even connect the cx-programmer to CP1L, using usb, toolbus (auto), sysmac way both thru port1 & port2
is there any way to reset it to factory setting ?

lostcontrol

Aug 18 2009, 05:38 AM

QUOTE (electron @ Aug 17 2009, 10:47 PM)

Have you tried removing the power source and disconnecting the battery?

This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.