Forums.MrPLC.com: TP Block in ccw - Forums.MrPLC.com

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

TP Block in ccw Rate Topic: -----

#1
User is offline   dhoyt1234 

  • Newbie
  • PipPip
  • Group: MrPLC Member
  • Posts: 7
  • Joined: 09-May 13
  • Country:United States
    United States
Im doing my first project with ccw. Im using a micro 830 and all Im trying to do is get this pulse timer to work.... Ive have gone as far as setting up nothing but one rung with a direct coil and a TP block and a single output. I did a build and downloaded the controller. I go into debugging mode enable my direct coil but the timer wont start... What am I missing here??????
0

#2
User is offline   HKU_MS 

  • Sparky
  • PipPipPip
  • Group: MrPLC Member
  • Posts: 36
  • Joined: 20-February 13
  • Country:United States
    United States

View Postdhoyt1234, on 09 May 2013 - 04:41 PM, said:

Im doing my first project with ccw. Im using a micro 830 and all Im trying to do is get this pulse timer to work.... Ive have gone as far as setting up nothing but one rung with a direct coil and a TP block and a single output. I did a build and downloaded the controller. I go into debugging mode enable my direct coil but the timer wont start... What am I missing here??????



The Pulse Timer has to be linked with an edge detector in CCW to work properly when you drop a pulse timer on the rung left click on it and use F1 to bring up help
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users