Forums.MrPLC.com: QC30R2 (RS232) - WIRING - Forums.MrPLC.com

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

QC30R2 (RS232) - WIRING Rate Topic: -----

#1
User is offline   andreik 
Posted 18 June 2012 - 04:35 AM

  • Sparky
  • PipPipPip
  • Group: MrPLC Member
  • Posts: 26
  • Joined: 12-April 12
  • Country:Philippines
    Philippines
Good day,

I'm very curious about the Mitsubishi programming Cable "QC30R2". I've got a feeling that it's just a "direct-wiring" Cable. What I'm trying to convey is that I think it has no special circuitry so perhaps I could just make my own instead of purchasing a unit. I've been searching through Google but I couldn't find anything. I'd appreciate any help. Thank you very much.

Sincerely,
Andrei K.

Attached thumbnail(s)

  • Attached Image: QC30R2.jpg
  • Attached Image: QC30R2-v2.PNG

0

#2
User is offline   kaare_t 
Posted 18 June 2012 - 06:24 AM

  • Guru
  • PipPipPipPipPip
  • Group: MrPLC Member
  • Posts: 891
  • Joined: 02-February 09
  • Country:Norway
    Norway
Straight through. However I'm not sure about the pinout, but I found these wirings depending on what cable/got you are using



Attached Image: Cable.png

Attached Image: GOT.png

This post has been edited by kaare_t: 18 June 2012 - 06:26 AM

0

#3
User is offline   KAZAH 
Posted 18 June 2012 - 07:21 AM

  • Sparky
  • PipPipPip
  • Group: MrPLC Member
  • Posts: 208
  • Joined: 17-October 05
  • Gender:Male
  • Country:Kazakhstan
    Kazakhstan
Posted Image

Attached thumbnail(s)

  • Attached Image: Снимок3.png

0

#4
User is offline   Crossbow 
Posted 18 June 2012 - 07:06 PM

  • Automation Engineer
  • Group: MrPLC Admin
  • Posts: 3,274
  • Joined: 30-January 03
  • Gender:Male
  • Location:Edge of Insanity
  • Country:United States
    United States
Q PLC is RS232 programming port, so there is no electronics in it like the SC09 cable. Kazah beat me to posting the wiring diagram, which is readily available from Mitsubishi.
0

#5
User is offline   andreik 
Posted 18 June 2012 - 07:06 PM

  • Sparky
  • PipPipPip
  • Group: MrPLC Member
  • Posts: 26
  • Joined: 12-April 12
  • Country:Philippines
    Philippines
Thank you very much, I really appreciate all the help.

Sincerely,
Andrei K.
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users