Sign in to follow this  
Followers 0
Kent Turley

CPM2C I/O bus error

2 posts in this topic

I'm hoping for a little insight into the following issue I have with the following PLC configuration: CPM2C-20CDR-D (1) CPM2C-16ETC 16pt expansion module connected to a G7TC-OC16-DC24 relay block (4) CPM2C-TS101 2ch RTD modules It has been in operation for about 11 years or so and within the last year or so, the PLC would occasionally error out. The customer would cycle power, the error would reset and continue operation. In the last couple months, the error was occurring more frequently to the point of at least a couple times a day. I contacted Omron and they thought the problem may lie in the power supply circuitry of the CPU. The CPU was replaced and am being told that in the last couple weeks, it has errored out twice since. So, now I am beginning to suspect field wiring as a possible cause? My question ... if there is some noise induced into the RTD lines, could that be a cause for the PLC to generate an I/O bus error and making the PLC fault? Thanks.

Share this post


Link to post
Share on other sites
I think if the power supply is OK, the next things to suspect are the bus connectors between the CPU/expansion modules, or one of the modules. Geir

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0