moneys

MrPLC Member
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About moneys

  • Rank
    Newbie

Profile Information

  • Country Malaysia
  1. PLC Advice needed!

    Indeed it is expensive for me but this is my UNI's course work which must be completed with a PLC and programming language like VB.net/VB express 2010 or any other language which may obtain real time data from a load cell and control the servo motor. So far i found out that Delta PLC is the cheapest and it have LOAD CELL module. The problem which i'm facing now are as below: 1) I am not sure whether this PLC will work in real time environment as i do not have enough budget to purchase another PLC later on. 2) The communication method between PLC and the programming language. Anyone can advice? Thankss
  2. PLC Advice needed!

    I need some further advice before proceed further to pick the PLC. Is it possible for VB.NET to communicate with DELTA PLC? Will the input from sensor display on VB.Net software instantly? PS~~I have limited budget for branded PLC as this is for my Study Course work.
  3. PLC Advice needed!

    OK. Thanks a lot for the advice. I will study and pick the PLC first and get advice from you again:) Once again, thanks a lot for the advices=)
  4. PLC Advice needed!

    Thanks for the advice. I'm new to PLC and i have low budget to start this development. I need to get advice from Expect on which is the best programming language to program the PLC (Will the Visual studio or C++ communicate with all PLC?) or is there any other programming language which will be better or easier to program any PLC? I would like to start to program the PC HMI/GUI first before go to PLC Part.
  5. Hi all. As above, i'm new to PLC and i'm planning to program a PC HMI/GUI (window 7 / 8) which can send command to PLC to control the servo motor and to receive data (i.e. Force reading, extension reading, speed) from PLC. (For example: tensile tester.) The data received shall used to generate some graph/report and later those data shall be stored in the database in CPU which may restore for future reference. Does anyone have experience or any idea to this? Which programming language (C++, VB etc ) shall i used to program the HMI/GUI and PLC. Please kindly advice or share some info?