beljic
MrPLC Member-
Content count
30 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout beljic
-
Rank
Sparky
- Birthday 09/09/78
Contact Methods
-
MSN
beljicdejan@hotmail
.com -
Website URL
http://www.beljic.n
et - ICQ 0
-
Yahoo
beljicdejan@yahoo.c
om
Profile Information
- Country Yugoslavia
Recent Profile Visitors
1574 profile views
-
Customer wants to sit in office and use files from card... This is what I offered then: two rs232 to rs485 converters (distance from office and PLC is about 100-150m), cables and cx-programer for downloading files from CF card and Java software whitch convert downloaded CVS files into one Excel file.
-
Thanks, well, in my country engineer time is mutch cheaper than hardware... Only thing I need is to transfer all files and folders form CF card to hard disk. At this time my customer use CX-Programer to transfer files... That is very hard for them ... He transfer file by file (there is alot of files on card)... It is slow, cant transfer folders...
-
Ftp is ok, but I dont have ethernet card. Can FINS commands be used for transfering files from PLC's memory card to PC?
-
I will check, thanks. Is it posible to create some software (in Java or Delphi) for reading CF Card?
-
What is the easiest way to transfer files from CF card to PC?
-
Try to change Com1 Node to 1. I made my own cable (look at NTXS manual), connected PLC RS232 port and NT3S port 1 and it work.
-
Set protocol in CX programer to HostLink (Standard), Unit number 1 (PLC Settings/HostLink port). In NT-XS go to network configuration and set Com1 - Omron HostLink, Address - 01(for PLC-NT3S communication) Com2 - IBM Communication protocol (for programming). What cable you are using?
-
I am using Epson LX 300
-
1. Make RS232 cable. Cable shemas you can find in download section. 2. Change settings in CX programmer (PLC Settings/Host Link Port) to Custom communication , Mode RS232C. Baud and format should be same as on psu. 3. Send data on rs232 port using TXD instruction.
-
Settings/Peripheral Port/Unit number. Unit number must be same in PLC and NT3S. After power switching Communication PLC-Touch screen works. Thank you very much for help.
-
I puted CPU dip switch #4 in ON position ... but still don't work. Settings for peripheral port in CX: Protocol Host Link, Unit No.1. Maybe is problem with cable?
-
I tried to connect PLC(*) - NT3S touch screen using Host Link protocol. But this dont work. *Peripheral port + CN118 + RS232C cable
-
I tried to use CS1W-CN118 to convert peripheral port to RS232 but couldn't setup paramethers in CX programmer.
-
Here is my implementation of A1S68AD: A1S68AD Function block ANALOG_PRG.txt Program with instance of A1S68AD A1S68AD_IMP.txt