Posted 20 Nov 2015 Any way to use a SCO9 and a homade cable? Any tips appreciated. Share this post Link to post Share on other sites
Posted 20 Nov 2015 Well spotted. It is a F1. Medoc only? Share this post Link to post Share on other sites
Posted 20 Nov 2015 The PLC is very ancient. The SC09, FX-USB-AW etc are not applicable: its programming port is 40pin parallel port. You'll need in rare tools to connect with it and will face with problem to purchase these tools. There are several topics in the forum, where the communication tools are listed... To replace the PLC with a modern and to write a new program for it will be much easy and quick! Share this post Link to post Share on other sites
Posted 20 Nov 2015 Welcome. You got a road map, but it's at your choice, to stay or to go by route. Share this post Link to post Share on other sites
Posted 20 Nov 2015 Where is the F1 located? I have the equipment to upload from F series PLCs Rodney Share this post Link to post Share on other sites