Sign in to follow this  
Followers 0
SESA218461

Tricky Communication in between RTU and SCADA Front End Processor

3 posts in this topic

I have the following situation; I have a distribution network connecting about 400 RTUs, using 101 protocol to connect to their PDH MUX, which data slot is transported using SDH STM-1/4, to the Primary Substations. Then the primary substations connect to the LDC building using STM-16. At the Control Centre Building where the Front End is located, there is a STM-16 node with some PDH ports, but definetly not 400, so how can I extract this 101 asyncronous data channels to connect them to the SCADA Front End? Note that conversion to 104 is not allowed by the client. Thanks in advance!

Share this post


Link to post
Share on other sites
Too many acronyms. What type of RTUs? What's the physical medium? What's the hardware/software on the SCADA side?

Share this post


Link to post
Share on other sites
101? MUX unit - hate them!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0