plcreyes
MrPLC Member-
Content count
9 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout plcreyes
-
Rank
Newbie
Profile Information
- Country Panama
-
IP of micrologix 1100 is erased when turn off power supply
plcreyes replied to plcreyes's topic in Allen Bradley / Rockwell Automation
Thanks Guys, now every thing is ok -
IP of micrologix 1100 is erased when turn off power supply
plcreyes posted a topic in Allen Bradley / Rockwell Automation
Hello, why Micrologix 1100 IP, is erased when turn off the power supply? Severals times I did set the IP on channel 1 but this is erased when turn off the energy. -
Yes, I did use the rslink server, and set the hardware number with temporally IP, then get the procesor with ethernet drive and set the IP. Following information about IP address. PANEL VIEW C600: 10.120.29.171 MICROLOGIX 1100: 10.120.29.170 LAPTOP: 10.120.29.172 All intgrated under ethernet switch. Thanks, Marcos Care to share your hurdles and final solution? Other newbies might learn from and avoid your mistakes. Yes they'll make their own, but at least they'll be able to avoid the ones you made if the can read.
-
At this time every thing is ok. Thanks a lot guys
-
Hello, Thanks, for your help . Now I am able to get the plc from my laptop by ethernet, but I have a problem trying to set the permanently IP ADRESS in channel 1 of processor. I did check BOOT ENABLE, write the IP, SUBNET MASK, and GATEWAY, then uncheck BOOT ENABLE OPTION, and appear the IP PERMANENTLY in PLC. Turn off the device and then I need to go again to BOOT-DCHP SERVER to assign the IP because is erased in PLC. Please let me know whats going wrong.
-
Hello, Thanks for your answer. Yes, one side it is micrologix 1100 with ETHIP with IP (169.254.0.1) SUBNET MASK(255.255.0.0), the driver is configured in (BROWSE REMOTE SUBNET) option of RSLINK. The We have betwen two devices a Stratix 2000 Ethernet Unmanaged Switch, then We have (Panel View C600) touch screen, with IP(169.254.0.2) SUBNET(255.255.0.0), same setting to program device from LAN NET in my LAPTOP. On comm option, I have the addres of micrologix 1100 with same IP that ETHIP DRIVER of RSLINX. Some thing is wrong, because I didnt get with ETHERNET the proccesor from my laptop . Other question is about ETHERNET CABLE, is possible to use straight or is necesary crossed cable? Thanks for your fast answer, Marcos
-
-
hello Im triying to conect two micrologix 1100 and panel view c600 with stratix 2000 ethernet switch, any idea about ethernet settings in two micrologix and panel view c600. Thanks
-
Hello, Im trying to instal the new firmware 1.50 on Panelview C600,but I cant transfer the autorun fille from USB MEMORY device. Any idea how is the corrct way to install this firmware.