Edwin

Hi All, I tried to remotely access the FX3GE by data monitoring is ok. However i can't connect it through GX-Works2. May i know how to set the port no:5556 or 5551 in GX-Works2?

I do not think it is possible to connect the GOT via USB and link with the FX series across the ethernet. But you can use the RS232 to connect the GOT and link with the FX series across the ethernet.

The program are in "Vamatex_Inverter" folder, but there are few versions of programs. you need to confirm which one is the latest program. Download procedure: 1. Online--> Transfer setup-->Set the correct com port and connection test--> if successful then 2. Online--> Write to PLC--> Select the program + Parameter then execute.

https://www.dropbox.com/s/t0rbqbd6om...ishi.rar?dl=0%7C above link is error.

that website just show you those HMI which able to link with CCLINK. http://www.cc-link.org/sch/c010List?langSeqNo=2&bunruiNm1=CC-Link&catTemplateSeqNo=6 (change it to English Language)

propose as below link: http://www.cc-link.org/sch/c010List?bunruiNm1=CC-Link&catTemplateSeqNo=6

A1SH CPU do not support USB port. You need to confirm your com port number at your PC Device Manager and use SC09 to transfer the program.

Just try to set all parameter to factor default and test. If it can work, probably you need to post your parameter here for checking.

You might try to download the default parameter with the existing program. If it is able to set the keyword, that means you might need to double check on your parameter setting.

I believe the wiring will same as attached photo.

No way to lower the FX3U version same as FX2N?

i have 5 stations of FX2N PLC link with N:N network by FX2N-485-BD. Currently i only want to change one of the slave station (eg. Station 3). to FX3U PLC + FX3U-485BD. May i know any program different between the N:N parameter setting for FX2N and FX3U PLC? FX2N PLC as a master still can drive the FX3U PLC as slave?

https://dl.dropboxusercontent.com/u/59958371/error%20code%20of%20GOT.png Probably you can provide the CPU you used and check from CPU side.

Just consider the FX3GE = FX3G PLC+FX3U-3A-ADP+FX3U-ENET-ADP will do.

Dear All, May i know how to communicate the QJ71C24N-R4 to FX3U-485-BD? Any method to writes the programs to refresh the share data such as M0~M10 and D0~D10?